RGB/RGBW Control panel R8-1 - control panel for colored RGB or RGBW LED strips, with a touch wheel, for controlling one zone. The operating frequency of the remote control is 2,4GHz, the signals of this frequency can spread further and are less disturbed by obstacles such as wall partitions, etc.
The main features of the RGB remote control:
- It has a sensor wheel that can be used to adjust the color of the lighting.
- The ability to tighten or brighten the lighting 10 levels.
- Ability to set 4 lighting colors and save them. To save the corresponding color, you only need to hold down the corresponding "Scene" button marked S2, S1, S2 or S3 for 4 seconds.
- There are four standard color buttons to activate the corresponding color: R - Red, G - Green, B - Blue, W - White.
- In order to extend the controller's battery life, the remote control is programmed so that if no action is performed for several seconds, the controller's touch wheel goes into sleep mode. In order to control the remote control with the touch wheel again after a while, you need to press any button on the remote control, so the touch wheel "wakes up" from sleep mode.
Connecting to the controller:
- We connect the LED power source, respectively 12V or 24V, depending on the voltage of the LED strip you plan to use.
- We connect the LED strip
- We connect everything to the network. If everything is connected correctly, the light marked "RUN" should start to glow blue.
- There is a small hole in the case marked "MATCH" and it contains a button. After pressing that button, the "RUN" light will flash, which means that the controller is ready to connect to the control panel.
- We press any button on the selected control panel. If the "RUN" light blinks again, it means that the remote has connected to the controller and the corresponding LED strip can now be controlled.
RGB control panel R8-1 is universal, like other remote controls in this series, they can work with practically all offered controls, in addition, these remote controls can work together with wireless wall switches.
Controllers that are suitable for connection with the R8-1 remote control:
- RGB color bar control controls: V3, V3-L, V3-X, V4-L, V4-D, VP.