Contactless LED controller OPTO
LED Controller with dimming function for installation in LED profiles.
Features of the controller:
- The controller is intended for indoor use only and for small voltages of 12V or 24V.
- The total power of LED strips or LED lights that are connected to the controller cannot exceed the specified (see characteristics).
- Installation of the controller must be done according to the instructions.
- The voltage must be switched off during installation. It is best if a specialist does it.
- Use only dry cloths for cleaning. Do not use any cleaners.
- The controller has memory. This means that after setting the correct luminous flux, the luminous flux will remain as it was last set after switching the light source off and on again.
Controller operation:
When everything is properly installed and connected to the mains, the blue indicator light should be on. This means that the controller is connected correctly.
Activation: In order for the controller to turn on the LED strip or lights connected to it, you only need to wave your hand 5-10 cm from the controller.
Shutdown: To turn off, also wave your hand.
Dimerization: In order to control the light flow, you need to keep your hand at a distance of 5-10cm for more than a few seconds. For the first time, the light flux will increase. Taking your hand away and holding it again for more than a few seconds will help reduce the light output to the required level. As long as the controller feels the hand, the intensity of the light will change. When the hand is withdrawn, the light flux will remain as it was set.
Contactless LED controller OPTO - A high-quality LED controller is perfect for under-cabinet lighting in the kitchen.